Inquiry (采购产品): Budgetary Cost REQUEST FOR BUDGETARY COST ANALYSIS FOR A SPOT WELDER The following below are characteristics, support equipment, and necessary information for a spot welder: 1. Turn-key installation at North Island, CA 2. Vertical press type 3. 3 Phase DC rectified 4. Total electrode 4” stroke; ?” working stroke, and 3 ? retraction stroke 5. 75 Kva rated at 50% duty cycle 6. Maximum of 60,000 peak short circuit secondary amps for 5 cycles without saturation. 6. Inlet water manifold and strainer assembly, closed water drain circuit 7. 36 inch throat depth 8. 2900 lbs electrode force at 80 psi 9. Complies with MIL SPEC AMS-W-6858A for welding specification 10. Control circuit functions programmed with touch pad. 11. Solid-state circuitry control 10. Microprocessor control with up 75 weld schedule memory 11. Electronic air-loaded pressure regulators to control air pressures 12. Hydraulic jack for raising and lowing bottom arm. 13. Lower arm adjustable over range of 9” and maximum of 18” 14. Weld capacities: Aluminum alloys 0.016 0.064 Stainless steel (300 Series) 0.016 0.070 Clean mild steel 0.016 0.125 Request estimated costs and lead time: Spot welder PC&H and Shipment (to CA) Training (one day operator, one day maintenance) Lead time **** Hidden Message ***** Edward Conrad 8000 Jefferson Davis Hwy Richmond, VA 23297 USA Company: Defense Supply Center, Richmond Title: Equipment Specialist Phone: (804) 279-4550 E-mail: edward.conrad@dla.mil **** Hidden Message ***** edward.conrad@dla.mil
