Inquiry (采购产品): Metal Bending To whom it may concern, My name is Jeremiah Lewis and I am the technical director for Maine State Music Theatre in Brunswick, ME. We have a couple of pieces for or current show we are in need of having bent. It is two pieces of 1-1/2”x1-1/2” 14ga box tube we need bent into two arcs with the following dimensions. Inside Radius : 1’-11-3/4” Inside Radius Arc Length : 4’-11-1/4” Outside radius : 2’-1-3/16” Outer radius arc length : 5’-3-1/2” Overall we would be OK with just getting the two piece bent to the correct outer radius a bit longer than to arc length and finishing the cuts ourselves. We are on a bit of a time crunch, and we were hoping we could get this taken care of very early this coming week. If you could let me know if that time table is possible, and approximately how much you think it will cost if we provide materials it would very much help me out. Thanks you very much for your time, and help on this. Regards, Jeremiah Lewis **** Hidden Message ***** Jeremiah Lewis 22 Elm Street Brunswick, ME 04011 USA Company: Maine State Music Theatre Title: Technical Director Phone: 207-725-8760 x26 E-mail: techdirector@msmt.org **** Hidden Message ***** techdirector@msmt.org
