Inquiry (采购产品): Vacuum Belts Have had no response from the note below.... 'bzimmer@midwestrubber.com'; 'tthompson@midwestrubber.com' Bill and Todd, I work for Xerox Corporation in Webster , New York We are working a joint project with Standard Dynamics and Telstar Corporations. Standard Dynamics and Telstar are using a belt manufactured Midwest Rubber. The current part number is …. IV-1022-2 The belt is currently 50mm wide. We would like to order belts 80mm wide of the same material and length. The vacuum holes and locations of the holes in the belt are currently be optimized. We would like to discuss our new steps for the order of the new width belts (80mm). A few questions… 1.) Can the current belt material be cut to the new requested width? 2.) Can the holes in the belt be cut after the belts are slit to width? This would allow our team to order the raw material and have the belts cut to the new width (w/o holes). Please let me know your thoughts. Best Regards, Paul Richards PSG Media Handling & Acquired Products Partner Finishing Xerox Corporation 800 Phillips Road, Mail Stop 0207-01Z Webster, New York 14580 Bld. 207 Phone (585) 422-3637 Internal 8*222-3637 Cell (585) 727-0359 **** Hidden Message ***** Paul Richards 800 Phillips Road Webster, NY 14580 USA Company: Xerox Corporation Title: Mechanical Design Engineer Phone: 585-422-3637 E-mail: paul.richards@xerox.com **** Hidden Message ***** paul.richards@xerox.com
