Inquiry (采购产品): Request an estimate I would like to have an estimate for your making 100 of the devices in the attached picture. The prototype is made with metal rods. I would like an estimate for making a small number in plastic or fiberglass, and an estimate for making 10,000 or more after I have market tested the device. The general specifications are: The straight shaft is approximately 10 inches long and 1/8th of an inch in diameter. The exact length and shape are not critical. The hinge is a universal hinge but could be a simple hinge that would allow the two members of the device to be folded together. The hinge must be stiff enough to hold the hooked part of the device horizontally at 90 to 120 degrees from the straight piece. The piece with the angled end is approximately 7 inches to the angle with 3 inches bent back at an angle of approximately 35 degrees. The part that is bent back must be in the same plane as the other section. The part that is bent back and the approximately 3 inch portion immediate adjacent to it on the 7 inch section must be of clearly distinct colors - shown as blue and red on the picture. The 10 inch shaft should be marked with a trademarked name and the phrase "Patent Pending" Thank you. Joel Reaser jreaser01@comcast.net 571-643-1112 (cell) Please respond with an email address to which I can send the picture as an attachment. **** Hidden Message ***** Joel Reaser 17222 USA Company: Individual E-mail: jreaser01@comcast.net **** Hidden Message ***** jreaser01@comcast.net
