Inquiry (采购产品): hose fittings questions Sir/Madame: I am looking for a good way to make some breathing air hose assemblies. The pressure in the hose will be low, about 1/2" W.C. The supply side hose is REDAR-A10999-2, 7/8" I.D., to which I would like to screw on a stainless steel quick connect with 1/2"NPT female thread on one end and a brass fitting with 3/4"NPT male thread on the other end. Any suggestions on specifing fittings for the hose so I can screw on the connections? I might have used a barbed fitting hose connector except I can't find it in 7/8" size. The exhaust side hose REDAR-A11016-2, 3/4" I.D., which needs the same threads on the ends as the supply hose. In addition is there a good way to make a hose-to-hose connection to join two equal I.D. size hoses together? Again, I can't find a 7/8" barbed hose connector fitting. I will be back in the office on Monday. Thank you for your attention to this matter. Gary Haynes, Engineering Designer phone: 865 576-3359 email: haynesgp@y12.doe.gov BWXT Y-12, Oak Ridge, TN **** Hidden Message ***** Gary Haynes PO BOX 2009 MS8193. Oak Ridge, TN 37831-8193 USA Company: BWXT Y-12 Title: Engineering Designer Phone: 865 576 3359 E-mail: haynesgp@y12.doe.gov **** Hidden Message ***** haynesgp@y12.doe.gov
