Inquiry (采购产品): miniture rotary solenoid I require a solenoid for a shutter assembly we are designing for a camera lens. Here is the specification for the shutter assembly: The dimensions of the solenoid body should be maximum of approx 12mmdia x 30mm long. Initially the requirement is for 2 or 3 off but production for next year will run at 75 per month Shutter A shutter mechanism is required to blank the IR scene to the detector for the purpose of calibration. The temperature of the shutter will also need to be measured for the purpose of calibration by a thermistor attached to the lens. Fixing required (M3) on lens for thermsitor. The shutter shall therefore rest in contact with the lens in order to reach thermal balance. Shutter connector : Molex 1.25mm series 510210200 housing. Pin 1 positive. Scene to sensor (open state) IR scene fully transmitted Scene to sensor (closed state) Black body radiation from shutter at indicated temperature Drive power (steady state) Minimal or none Drive power (moving) Up to 50mA at 5V (minimise if possible) Time open to closed <0.1s Closed time state 0.05s nominal Time closed to open <0.1s Please advise if you can supply a solenoid to suit this application Regards Simon Pascoe **** Hidden Message ***** Simon Pascoe WD24 7GW GBR Company: Davin optronics E-mail: simon@davinoptronics.com **** Hidden Message ***** simon@davinoptronics.com
