Inquiry (采购产品): worm gear receiver I have an old Walker Turner floor drill press and have moved a couple of times and lost the part that attaches to the adjustable bed platform. I have the crank handle with the bevelled pinion gears and the worm gear shaft, but I don't have the female (nut) part that would raise and lower the bed. The worm shaft is 5/8" diameter on the outside of the grooves and 1/2" diameter at the bottom of the grooves. the grooved area is 12" long and I counted 95 grooves, which adds up to 8 grooves per inch. There is a 4" diameter ring that has a ledge extending to 5" diameter which is 1/2" thick attached to the bed platform which is where the nut part attaches. If I had a female nut type receiver that would thread into this worm gear. I might be able to make this thing work. I would like to know if there is a part of this type available and what it will cost? Any information would be greatly appreciated. Thank you very much for your time and effort. patman1562@adelphia.net **** Hidden Message ***** Patrick Halliman 5665 South Park unit 19 Hamburg, NY 14075 USA Company: NFTA Phone: 716 648 7647 E-mail: patman1562@adelphia.net **** Hidden Message ***** patman1562@adelphia.net
