Inquiry (采购产品): a custom mold I am hoping you can help me. I have an item (a ceramic figurine) that I want to reproduce to sell in my area. It is in 4 pieces that stand next to eachother to form 1. (picture an elephant divided into 4 pieces). I do not know where to begin. Do I have a mold made then make the item either myself or somewhere else or do I have the mold and item made in the same place? Which is more cost efficient? I might have notified you sometime in the past, but put off acting on any information. I am now ready to proceed but need to know the approximate cost and procedure to start.Each piece is approximately 1 1/2 to 2" wide by 2" tall by 1" deep. I visit Conn often and would like to meet with someone if possible to discuss this. If this is not what your company does, can you point me in the right direction? Thank you in advance for your help. Suzanne Dubuc, 94 Wesley Dr., Charlotte, VT 05445 (802) 651-1549. **** Hidden Message ***** Suzanne Dubuc 94 Wesley Drive Charlotte, VT 05445 USA Company: Dubuc's Phone: 802-651-1549 E-mail: sdubuc@doc.state.vt.us **** Hidden Message ***** sdubuc@doc.state.vt.us
