Inquiry (采购产品): Fabricate a part I need a flywheel and shaft fabricated. I would like this to be one solid piece when finished. Here are the specs. The flywheel needs to be centered on the shaft. Flywheel diameter is 24" Flywheel width is 0.125" Flywheel material is stainless steal. The shaft length is 5.625" The shaft diameter is 0.5625" Each shaft end will need to be tapered down a length of 0.75 to a diameter of 0.5". This needs to be 90 degrees sharp. The ends of the shaft will be inserted into bearings so tolerance is critical for that piece only. Tolerance needs to be .001 The shaft material is stainless steal. This part will spin at 15,000 RPM so it will need some balance. We will perform final balance after we install but anything you can do to get it as close as possible will help.. Can you please provide me a cost to fabricate. Time to fabricate. You are local so I would like to Will Call it. Thank you, David Knapp **** Hidden Message ***** David Knapp 90275 USA Company: Jada Engineering and Technologies, Inc. Title: Owner E-mail: david.knapp@jadafoundation.us **** Hidden Message ***** david.knapp@jadafoundation.us
