Inquiry (采购产品): Bending Extruded Aluminum Valences We are manufacturers of plastic cases used for carrying/storing computers, instruments, cameras, drills, etc. I would like to know if you have expertise and/or equipment to bend an H section of extruded aluminum on approximately a one inch +/- radius, maintaining the space between the H Legs after bending. The entire section may be only 2" in cross section (height of H section), and about 1/2" wide (width of H section). The thickness of aluminum is approximately 1/8". The H section is actually made up of two parts, separated at the center of the H horizontally, making two pieces, an upper "U" section, and an "upside down U section as the mating piece below. These sections form the frames for matching shells which for our plastic cases. I would like for someone to write or call me. My telephone no. is 909-930-5668. Thank you for your help. Paul Lopez **** Hidden Message ***** Paul Lopez 91761 Company: California Quality Plastics, Bel Air Division E-mail: plopez@calplastics.com **** Hidden Message ***** plopez@calplastics.com
