Inquiry (采购产品): brass tubes I am looking for small diameter, thin wall (i.e. 0.005 – 0.010 in.) hard brass or stainless steel tubes for use in the manufacture of ferrule sets for fishing rods. A total of four different tube diameters are required for two sets of ferrules. Each ferrule set will be approximately an inch in length and has an inserting tube and a receiving tube. The tubes must couple, one inside the other, with a reasonably close fit. (i.e. 0.005 to 0.010 in.) Typical desired dimensions are as follows: Inserting tube #1: O.D. = 0.130 in. (3.3 mm), Inserting tube #2: O.D. = 0.180 in. (4.6 mm) Receiving tube #1: I.D = 0.135 in. (3.4 mm), Receiving tube # 2: O.D. = 0.185 in. (4.7 mm) If you have such tubes, please send dimensions for your standard sizes that are closest to those listed above. I would also like price and delivery information as well as your minimum order requirements. Tubes should be shipped in lengths of 5 ft or less. We will cut to the required lengths for ferrules. If you do not have these materials, I would appreciate any information as to where I might find them. Thank you, J. C. Kollodge Sisters Compound Rods P.O. 184 Sisters, OR, 97759 E-mail: kollodge@prodigy.net Ph: (541) 549-1639 Fax: (541) 549-1844 **** Hidden Message ***** Jerome Kollodge P.O. Box 184 234 E. Adams Ave. Sisters, OR 97759 USA Company: Sisters Compound Rods Title: Owner Phone: (541) 549-1639 Fax: (541) 549-1844 E-mail: kollodge@prodigy.net **** Hidden Message ***** kollodge@prodigy.net
